|
I picked the holder up from the wreckers for a few dollars. It came off a minivan. (give me a day to remember which van.) At first glance it appeared to fit pretty well but I had to trim a lot off both sides and top. It fit pretty good but it stuck out way too much. All I used was a knife to trim away until it fit nicely. I'll take a picture next time it is off to show how it is mounted.
Think of it like this: It was a large piece of plastic that you just need to shave with an exacto knife until it fit properly. Not much work but a little time consuming.
Originally I wanted the top of the license plate holder to sit in the groove of the bumper. It looked amazing but it blocked too much of the radiator which seemed like it would just cause problems.
|