MX6.com - View Single Post - HOW TO use a mill to mod your fe3 rail for rx7 injectors

**fredio54** · 5-24-07, 13:57

i tried that first. but i couldnt get the finish. did you get a nice finish (if so, you are the man) or did it just seal on luck? brave man without access to an infinite supply of rails.

good on you though.

fred.

5-24-07, 13:57	#3 (permalink)
fredio54 Join Date: Aug 2004 Location: Auckland, New Zealand iTrader: (1)	i tried that first. but i couldnt get the finish. did you get a nice finish (if so, you are the man) or did it just seal on luck? brave man without access to an infinite supply of rails. good on you though. fred.
	DIYEFI.org - TRUE DIY engine management Mazda FE3/FE-DOHC Master Index Thread (work in progress) Mazda truck with FE-DOHC/FE3 "BIG like your house" Holset Turbo drinking 2.2 litres of fuel per minute ~= 385hp crank RIP SleepCounter :-( we will miss you! - RIP fredio54 :-( will we miss you?