|
MS2 with ms2e code v2 alpha
V3 board with extra power feed pin and heavy wire inside for flyback (deficiency in original design, but only matters with low Z injectors)
4 cyl cop with duplication of led circuit for indication of all coils firing from inside the cab
the jumpers required per following the intructions for my needs (just followed them like everyone else)
both std v3 vr sensor circuit, and opto circuit in use
opto hooked to single slot signal with pullup resistor to 5v rail inside ms
vr hooked to ford edis vr sensor and 36-1 ring on crank
might link the pics later if i can be bothered. and my msq (which is rough) and datalogs are hosted elsewhere...
shoot with questions, i'll do my best to answer if i can :-)
fred.
ps, good idea.
|