|
nice write up! "must spread..."
its worth pointing out that with a bit of extra circuitry and/or some gt dizzy mods you can have it running with a lot more accuracy during accel events. having said that, you dont really need to, and considering the inertia of an f2... there isnt much point.
if anyone wanted to do it, they need two vr sensor inputs with lifted grounds for the stock setup, OR 2 teeth ground off the 24 tooth section and a single vr sensor circuit.
i strongly agree with your choice to NOT use a relay board, i think they are a problem, not a solution.
its worth noting that the v2.2 board is more susceptable to noise, and not capable of running low imp injectors without another board, or inline resistors.
keep up the good work :-)
fred.
|