|
I dig those pix of compnut21, they have color! My little WSM does not and it can be a pain tracing the harness on the small drawings.
BTW, the instructions at the beginning of the wiring section are very helpful, probably better than any shop manual I've used.
In case you haven't already figured it out, the power source code across the top of the page showing, "A, 2,1, S, B," mean the following:
A -- Accessory Power Source
2 -- Ignition Switch 2 Power Source
1 -- Ignition Switch 1 Power Source
S -- Starter Power Source
B -- Battery Power Source
Now, obviously, when the ignition switch is OFF, the "B" buss only has voltage. When key is in the ACC (accessory) position voltage is supplied only to the "A" and "B" busses. When key is in ON position, voltage is supplied to "B" "A" "1" and "2" busses. Finally, when key in in ST (start) voltage is supplied to, "B" "1" and "S" busses only.
|