M2CupCar did some good work yesterday!
He was having a few issues with leakage and boost, and upon discussion did a temporary setup for his pcv where he rerouted the in to the out and vice versa including moving the valve over. Apparently this helped quite a bit (not too surprising really. Heres the temp setup :
Further to that he pulled the fitting on the end out, and found the hole inside to be really small. so he replaced it with a large fitting. he also bored a hold in the back of the other bank.
Here are the results :
Small hole (quiet in the cheap seats) :
New hole in the other bank :
Ready to go (mint!) :
Cheers Rob!
Fred.