|
Just saw this thread.
Do it right and use a welder.
For small holes get a piece of brass flat bar 1/2" x 1/4" and put it in behind the hole. when the hole is filled, remove brass and do your next one.
For larger holes (lock, antenna, doorhandles) put masking tape over top of the holes. Trace out hole. Remove tape. Place tape on new material(same gage as car sheet metal) Cut filler plate out. Hold your piece of brass across the back of where you are welding (helps dissipate heat and stops blow through)
Spot weld only!!!! And don't get the area to hot.
When hole is all welded up, grind down with a feathering disk.
Skim with a little filler(shouldn't need much)
Sand
and Paint
Looks good and lasts forever
Not saying the other way is totaly wrong, it's just not right LOL
L88888888
B
|