Window Motor

[Troy00690]

Just got an MX6 on sunday. Went to roll down the window yesterday and it made a grinding and clunking noise then the window fell to the bottom and the motor keep on spining. I pulled the door panel off and the motor out. The design of out window set up is puzzling. I have to replace the cables they got chewed up and bent. My question is does anyone have a diagram of how the cables go. I am new to this forum and not used to this forum. I searched through 14 pages of threads and clear back to 2004. Didn't find anything that was useful.

Thanks in advance Troy

[serial]

i'm not exactly sure if they're hte same, but if you pull the door panel off the other door you should be able to look in there and tell how it goes, just a mirror image of it. if it's your drivers side that broke, it should be easier because i think there is less going on on the passanger side with wires and excess crap, but i could be wrong on that.