KLZE Swap Help

Russ3llk · 5-15-08, 6:06

I currently have a 1996 m edition and im putting the klze in with the obdII wiring harness what can i do to get the full power. I have heard to put the j spec ecu and vaf in but i cant find either. i have also heard find someone who makes chips but i cant find one for the obdII.

**Scatman95** · 5-16-08, 21:14

AFAIK, chips arent made for any OBD2 6's. As far as the ZE goes, u cant just drop them into OBD2 cars, they dont come with the emissions hookups that u need and the JDM ecu/vaf combo also wont work for that same reason, Japan uses a differnt system than an EGR.

To get a ZE to run in a OBD2 with the least amount of work would require taking out your OBD2 engine wiring harness and putting in a OBD1 harness, as long as this wouldnt break too many laws in NC and would still allow u to pass emissions if u have to do that.

Russ3llk · 5-18-08, 18:07

what if i was to swap out the vaf and throw in a megasquirt ecu

**Scatman95** · 5-19-08, 10:50

that could work, run the MS piggyback to the original ECU, and have the original ecu run the EGR system you would need to hookup.

I would advise u to send Radar a PM, he should be able to help you out, he done lots of cars with MS.

5-15-08, 6:06	#1 (permalink)
Russ3llk New Member Join Date: Aug 2007 Location: Fayetteville, NC, USA iTrader: (0)	KLZE Swap Help I currently have a 1996 m edition and im putting the klze in with the obdII wiring harness what can i do to get the full power. I have heard to put the j spec ecu and vaf in but i cant find either. i have also heard find someone who makes chips but i cant find one for the obdII.

5-16-08, 21:14	#2 (permalink)
Scatman95 Join Date: Dec 2006 Location: Beechwood, WI, USA Age: 23 iTrader: (6)	AFAIK, chips arent made for any OBD2 6's. As far as the ZE goes, u cant just drop them into OBD2 cars, they dont come with the emissions hookups that u need and the JDM ecu/vaf combo also wont work for that same reason, Japan uses a differnt system than an EGR. To get a ZE to run in a OBD2 with the least amount of work would require taking out your OBD2 engine wiring harness and putting in a OBD1 harness, as long as this wouldnt break too many laws in NC and would still allow u to pass emissions if u have to do that.
	95 LS> IT RUNS 97 LS> my DD

5-19-08, 10:50	#4 (permalink)
Scatman95 Join Date: Dec 2006 Location: Beechwood, WI, USA Age: 23 iTrader: (6)	that could work, run the MS piggyback to the original ECU, and have the original ecu run the EGR system you would need to hookup. I would advise u to send Radar a PM, he should be able to help you out, he done lots of cars with MS.
	95 LS> IT RUNS 97 LS> my DD

5-18-08, 18:07	#3 (permalink)
Russ3llk New Member Join Date: Aug 2007 Location: Fayetteville, NC, USA iTrader: (0)	what if i was to swap out the vaf and throw in a megasquirt ecu