|
When checking the codes ..
Q: Can you explain in more detail how the codes are flashed out/displayed?
A: the LED will do the following..
Say you had 3 codes. Ie 15 24 9. ( just hypothetical example) it would do the following
- = a long flash
. = short flash
It would continullay repeat this:
- ..... --.... .........
It just keeps cycling through. So if you let it run through a few times you should be able to figure out how many codes you have and what they are
hope this helps
Q: is there a way to reset these error codes?
By using this instruction on my 95 MX-6 LS (ATX), I found 4 error codes: 9, 17, 23 and 24. But I'm not sure when did they happen. Is there a way to reset these error code to see if they happen again?
Thanks!
A: Disconnect the (-) negative terminal on the battery for a few minutes, by opening the door on the car, you will be triggering the cabin lights, This will drain all the remaining current/voltages from the electrical system , and thus blanking the ECUs memory
Q:I am going to assume this will not work on a 96-97 car... right?
A:That’s correct you will need a code reader form auto zone for that..
Last edited by ODIN : 2-13-04 at 7:28.
|