Was gunna use it but i'm using a rx7 steering wheel that I like much better.
Absolutly nothing wrong with it, its it perfect condition...
Just shoot me an offer.
Even if the cruise on that wheel doesn't work it looks like the mounting point is the same so you could just swap the one from your stock wheel onto it.
My vBGarage
1995 Mazda Mx-6: Money pit/driveway decoration
At least 20 bucks + shipping and if more then one persons interested i'll probably go with the better deal... just shoot an offer and pm me if you want a shipping quote. I can check out the contact points on the c/c tommorow i'm sure it works just fine. And no, this steering wheel does not have an airbag.
^^I figured as much, worst case scenario I would have to fab up a base for the steering wheel. As far as the light, I can get my brother to wire up a resistance or a bridge and get away with no light
Quote:
Originally Posted by whitenoyz
Your geese try to take down our planes. Thats close to an act of war.
You shouldn't even have to fab a base for the wheel. I believe mazda uses the same spline shafts on all of their steering columns but I could be wrong. I have never had my 3's steering wheel off.
My vBGarage
1995 Mazda Mx-6: Money pit/driveway decoration
If you want to get rid of the airbag light just unplug the module under the drivers side kcik panel... but make sure there is no power in the car. Unhook the battery! It also gets rid of that annoying ding when you start it up.
The AutoGuide.com network consists of the largest network of enthusiast-owned enthusiast-operated automotive communities.
AutoGuide.com provides the latest car reviews, auto show coverage, new car prices, and automotive news. The AutoGuide network operates more than 100 automotive forums where our users consult peers for shopping information and advice, and share opinions as a community.