Mazda MX-6 Forum - View Single Post - What Happened to Performanceprobe.com?
View Single Post
post #12 of (permalink) Old 11-11-18, 3:56
XfactorMX6
 
Join Date: Oct 2013
Location: Oxnard
Posts: 31
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 9 Post(s)
Power: 5
 
Quote:
Originally Posted by 04ProbeGT View Post
What box's do you have? Open then up and look in the top right corner you should see an fc3 or fc4 this well tell me what chips you need.
HKS FC4

Quote:
Originally Posted by 04ProbeGT View Post
As for the mixture control is the blue wire tapped into the box or is it tapped into the harness?
Mixture control is pinned into the plug that goes to the FCON, no wires tapped into box. Why did they do it both ways? Is there a difference?

[URL=http://s1166.photobucket.com/user/04_Probe_GT/media/HKSmix-2.jpg.html]

[URL=http://s1166.photobucket.com/user/04_Probe_GT/media/HKSmix-1.jpg.html]

Quote:
Originally Posted by 04ProbeGT View Post
Instead of using the fcd just run a an ecu that has a stock chip that has boost cut removed. The fcd is just a voltage clamp and leans out the top end, while the bc chips wont have that issue. If you need I have those chips as well.
Ok so no FCD needed. I have 3 chips here, zombie, probinator and one more unknown chip, will any of those work?

Quote:
Originally Posted by 04ProbeGT View Post
IF those are the correct harness ZP-4 (Check to see if you have a small silver sticker on the harness that has zp-4 as well as what eprom are in teh unit are tehy by chance E104?) harness then you just have to re-pin the injectors, but as you should be able to tell those 2 harness you have have different colored wires so its not like I can say what to do by color.
ZP-4 sticker confirmed on harness with control mixture box. Other harness is missing sticker but wires match up on every connector.
One chip missing sticker
Other chip says E149

Quote:
Originally Posted by 04ProbeGT View Post
IF you can get me a pic of the back of the harness only need one that way you can copy it on the second. I'll tell you what 2 wires to remove and what 2 wires to tie together and what 2 wires to connect.












Quote:
Originally Posted by 04ProbeGT View Post
See hes what the issue is the ZP4 has 8 injector wires 4 in and 4 out while the mx6 only uses 2 input and ties the 4 output signal into two pins on the ecu side of the jumper harness. So you have to cut out 2 of the input signals wires, patch those as a pass through, de-pin them from the back of the fcon plug as they are not needed and then tie the out put signals to the other 2 output signal wires.

All of those wires are located on the small plug its the only one you'll need to unwrap.
I should have read the entire post, was replying section by section. I will re-read this tomorrow morning when my brain is fresher.

Last edited by XfactorMX6; 11-11-18 at 4:02.
XfactorMX6 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome