Amber and chrome on bottom. The amber is indented if that makes sense
Sent from my iPhone using Tapatalk
Unfortunately the 5door has Aspec tail lights, It's an 88-89 front welded to a 90+ rear end (car was rear ended), was hoping they used 90+ tails but no. Wouldn't mater because the driver side is smashed anyway, passenger side is good and there is a spare passenger tail in the hatch.
I checked the boxes of lights I could remember the location of but only found MX6 lights, somewhere I have 626 lights but I don't remember if we pulled any touring sedan tail lights.
I did grab the deck lid cross bar. It is a rod welded to flat steel.
It is press fitted into the deck lid but was 90% detached so I pulled the rest apart, brought it home and cleaned it up.
Again it is usually pressed into the carpeted deck lid plank with many sharp 4prong circles, I think that using adhesive, a vice and a 2X4 that you can press/fasten the rod assembly to the deck lid.
Or you can get the same length rod, mark the rod position on the bottom side if the deck lid, take a tiny drill bit and drill holes in front and in back of the bars position, then use clear nylon or matching grey thread and tie/sew the bar to the deck lid.
My Email is [email protected]
if you Email a phone number I will send you pictures of the deck lid bar.
The asking price is the cost of a shipping tube (like a poster would go in) + shipping.