Mazda MX-6 Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
20 Posts
Discussion Starter · #1 · (Edited)
First off this is a feeler. Please only respond if your are interested, and only once.

I've contacted several manufacturers and am trying to get a pillar pod made for 93-97s. I basically need 30 people up front. Once everyone is accounted for, manufacturing would probably take about 2 - 3 months. I will be using Lotek
All money will be going directly to them, not me.

Let me know who's interested. if enough people respond, then I'll go ahead and set up a group buy.

Geoff

Edit: This will be for three gauges, the price should be between $40-70. Please email or private message me with any questions. Only post here if you are interested in purchasing one. Thanks.

Geoff
 

· Registered
Joined
·
20 Posts
Discussion Starter · #2 ·
Someone mentioned over at mazda626.net that the MX6 pillars would work on our cars. Well today I went to the junkyard, pulled a left and right side cover. They Do Not Fit. If we're ever going to get one made, we've gotta pull togehter.
 

· Registered
Joined
·
20 Posts
Discussion Starter · #4 ·
This is actually proving to be hard. I posted an interest over at mazda626.net over a month ago. Only about 14 people including myself expressed interest. We need at least 30 to get this thing going. I alos must admit that I have not invested any energy into this for several weeks now. I've been too busy with work and developing other products for our cars. After the Holidays I'll be able to put much more time into this. By then the Moroso oil pan should be finished, I should hopefully have my car back, and my rear camber plates should be finished. Then I will have more time to spend on this project. Until then, lets keep the interest coming. If 30 people aren't interested, this will never happen.

Geoff
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top