Mazda MX-6 Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
12,045 Posts
Discussion Starter · #1 ·
First, let me say that I haven't looked at the ignition wiring on a 93 LS for quite a while.

Now, I'm hoping I can get both male and female pigtails with wire so I can make splice connections outside of a 93 LS for a remote start. This way I can have an easier time soldering/heat shrinking everything.

If the ignition side is physically attached to the ignition, I would be interested in that socket since there wouldn't be any wires... plus the harness side.

If it's not possible to get both sockets, I'm interested in the one harness with 10 inches of wire if possible.

Again, this is for a 93 LS with a manual transmission (if it matters).
 
1 - 1 of 1 Posts
Top