Mazda MX-6 Forum banner
1 - 2 of 2 Posts

Discussion Starter · #1 ·
Hi, i am doing the install for my amp right now, but have run into a snag. I cant figure out where to put the power cable through the firewall. Whats the best and easiest place?
Thanks guys, i really need some help.


305 Posts

put it in through the black rubber cap (with all the wires going into it) in the firewall on the driver's side. You might beable to squeeze it through the cap with a flat head srewdriver and pull it through the other side underneath the dash under the steering wheel. If not you'll have to remove the black plastic cap and feed it through.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.