Mazda MX-6 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 · (Edited)
[Nevermind i got it figured out]

Im reaching the end of my ATX transmission swap(other died) on my 88 MX-6 LX, all the connecters on the trans harness are the same and attach, but one which wires match up(the color codes) but the connector isnt the same, am i going to have to splice my own connector, does anyone have any advice, the trans came from a 88 MX-6 DX and the vin number on it says it was made in japan while my car was made in Flint MI.

The 4 green wires(bottom right) are supposed to connect to the 4 blue wires(far left) but the connectors dont match

Thank You:help:
www.lawndalehomes.net/misc/test.html
 

·
Registered
Joined
·
1,434 Posts
I know this wont help but why would you do an ATX to ATX. I personally think you should have done an ATX to MTX. ATX = boring, slow, and for women (no offence) MTX = faster, more fun, and much more respectable
 
1 - 3 of 3 Posts
Top