Mazda MX-6 Forum banner

1 - 5 of 5 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Getting engine and auto trans out to replace engine. Up to pulling axels left side won't pop out. Any suggestions on what to use, not much room under there. Tryed screwdrivers long, and pull slide hammer with hook no go. Any body know what size socket to put in place of axel when pulling both out to stop gears from dropping down?
 

·
Registered
Joined
·
825 Posts
First learn to spell."Axle"
 

·
Registered
Joined
·
400 Posts
jay u really helped. r u a teacher or someting?
 

·
Registered
Joined
·
5,550 Posts
Well I had a problem like this once .. the one that came out I inserted a rod/big screwdriver and bashed it out from the other side .. this was only after all else failed.. but it didn’t do any harm..
You can just abut put any thing in to stop the spider gears from dropping off .. they have to move lower than the opening to fall off so as long as something is in there.. you should be ok.
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #5
Thanks for replies Got them out had to go to a 30" screwdriver to pry with.
 
1 - 5 of 5 Posts
Top