Mazda MX-6 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,291 Posts
Discussion Starter · #1 ·
i hit a curb the other day and bent my control arm, it wasnt that bad so i drove it home...i installed a new control arm and now my car doesnt move, it seems as if the axle isnt in the spindle its just kinda loose...do i have to take out my cv joint to put the axle back or is there a chance i could get it to slide in....or could it be that my half shaft is broken?
 

·
Registered
Joined
·
4,460 Posts
Well first of all, make sure that the axle is properly inserted into both the transmission and the wheel hub.

Outside of that, it most likely seems you've screwed up or disconnected the CV joint somehow...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top