Mazda MX-6 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
541 Posts
Discussion Starter #1 (Edited)
Wastegate Control solenoid

Does anyone know of a good two or 3 port upgrade??

I am trying to conect a TurboLink controller and the factory solenoid wont hold a steady pressure after about 10psi...
 

·
Registered
Joined
·
5,273 Posts
disconnect the factory solenoid all together. ive taken mine off.

i got a turbosmart incabin b/c in the process of getting it at the right setting
 

·
Registered
Joined
·
541 Posts
Discussion Starter #3
the link uses the factory one to adjust the boost by fooling the ecu... Only problem is the factory unit doesnt seem to be up to the job!
 

·
Registered
Joined
·
541 Posts
Discussion Starter #4
I am just hoping its not the wastegate itself that cant deal with 10 - 12psi.

To test this - if I disconect the solenoid complete - it *should* boost until the compressor wheel falls off yes?? If so I might try it and see if I can get a 12psi reading to make sure its not the wastegate thats ruining my fun!
 

·
Registered
Joined
·
5,273 Posts
No if u run one vac hose from turbo snout to waste gate solenoid it will run stock boost.
 

·
Registered
Joined
·
26 Posts
how can u get 10psi from ur stock solenoid im only gaining stock boost like around 6 to 7 ppl like gettin max 10 psi threw there solenoid how does dat work out?
 
1 - 6 of 6 Posts
Top