Hi, I see you've been around this forum for a short while, but there is a special sub-genre in this section called "Audio & Electronics" to which these types of queries belong.
-Cheers and good luck
-Cheers and good luck
Clifford alarm/keyless entry problem
In my mx6 i have a clifford alarm installed. Its a great alarm not to sensitive but just enough. it even play a catchy tune when you put the battery in the remote! The problem is though when i attempt to unlock the car with my remote it doesnt unlock and plays the song. I then press the lock button and it syncs with the car and re-locks the car. after that rarely i can push the unlock button and get the car unlocked without it playing that music. Is my remote needing to be replaced? reconfigured? will i have to install a whole new alarm system in my car?
The only info i have on the alarm at the moment is from the back of the remote.
RPN 488V/P/X
FCC ID: EZSDEI487
Thanks in advance
The only info i have on the alarm at the moment is from the back of the remote.
RPN 488V/P/X
FCC ID: EZSDEI487
Thanks in advance
1 - 9 of 9 Posts
Apologies.Hi, I see you've been around this forum for a short while, but there is a special sub-genre in this section called "Audio & Electronics" to which these types of queries belong.
-Cheers and good luck
I usually only post in the 2G forum since thats what i own,
Mods if you have the time move this thread please other wise i will just repost tomorrow
I would guess that you have a problem with your remote. If you got it installed somewhere, they might look at it for free.
Starting a new thread in audio/electronics. mods please close
I've moved this thread to the Audio/Electronics Forum for you and have deleted your other thread you started. This one has replies already, so lets use this one.
In the future, please take the time to check over the site and post in the most applicable section possible. It will help you gain the answers you need faster and more efficiently.
Thanks.
In the future, please take the time to check over the site and post in the most applicable section possible. It will help you gain the answers you need faster and more efficiently.
Thanks.
That would be he best bet but it was installed before i bought the car, leaving me with no information at all.I would guess that you have a problem with your remote. If you got it installed somewhere, they might look at it for free.
thats certainly a bit weird. I know vipers have code hopping where they change the alarm code every time the fob is locked. And Viper is either owned by or owns clifford so they are pretty similar. Could be what has happend is the remote is out of sync and just can't catch up with the alarm. Try to disconnect it from the battery for a few hours and reconnect it and see what happens. It'll give the alarms memory, if it has one, to be erased and maybe this will fix it. I'm not an alarm guy but i read a lot lol.
4cylfun.
thanks for your input. i tried this yesterday and once i put the battery back in it played the song. and operated like before. maybe the remote is just broken? it seems like it. sometimes i push the little antenna into the remote and it works after trying several times.
thanks for your input. i tried this yesterday and once i put the battery back in it played the song. and operated like before. maybe the remote is just broken? it seems like it. sometimes i push the little antenna into the remote and it works after trying several times.
1 - 9 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mazda MX-6 Forum
A forum community dedicated to Mazda MX-6 owners and enthusiasts. Come join the discussion about restorations, performance, upgrades, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
