Mazda MX-6 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter · #1 ·
Hey fellow Mx6r,
I'm having problem taking off the crankshaft bolt on the pulley. I tried that breaker bar method (bump da crank w/bar), but it didn't work to well. I purchase a compressor a 33 gallon 150psi 3.5 [email protected] and a 250lb torque impact wrench but no luck as well. I tried torching it, kicking it, baking it, and just about everything but the bolt is still stuck. Any good advice??

Thnx peeps
 

·
Registered
Joined
·
70 Posts
Discussion Starter · #8 ·
well I took it to my uncle shop today and they just used the impact wrench and it came off. they said the previous owner strip the bolt so the breaker bar didn't hold to well. thank you all for your input. I really appreciate it.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top