Mazda MX-6 Forum banner
1 - 3 of 3 Posts
Joined
·
126 Posts
Discussion Starter · #1 ·
hey all..it's been a really long time since i've been on here....
newayz, I was cruising w/ my boy today and he "rolled" his passenger power window down..what he didn't notice is that when he did this the power window button got stuck in the "down" position......after we got to where we were going (orlando magic game) we noticed that it wouldn't roll up...we managed to "free" the button but it still wouldn't roll up....my drive side window works fine...and the fuse for the power window is fine....where do I go from here???
 

· Registered
Joined
·
67 Posts
power window

HI

I had the same problem myself but on the driver side, but i think it's probably the same to fix.

In my case inside the powerwindow controllbox the handle broke...the dealer sells it for around $150...well i didn't wanted to spend on it so here is how u can fix it:

First take the interior cover of the door off(just a couple of screws...than it pops off...pretty simple) than disconnect the wires...there is a little switch box which operates the window(the one which is connected to the buttons which u use to operate the window with)...take that out and take it apart(it's really hard trust me...maybe it was only on the driver side!?) than get some super glue and glue the plastic peace back where u can c it broke off from(make sure the glue is strong enough and it holds at least under some pressure, since it has to move around as u push the button)...

Installation is the same the other way around

Since i did that mine works fine

Good luck

Janos
 
Joined
·
126 Posts
Discussion Starter · #3 ·
my switch still has the same "feel" to it it "feels" like it should be working.. in other words it's not like loose or jigly....did your feel any different than normal when it broke? thnx
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top