Mazda MX-6 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
Does anybody have some Instructions on how to build an Air-Intake that doesnt go underneath the car but stays inside the engine compartment like the PRM. If so please reply to my post.

Thanks
 

·
Registered
Joined
·
543 Posts
I just wanted to add that I recently shorteend my intake hose from 21 to 18 inch so that the filter now sits on the splashgaurd rather than hanging under the car like in that pick. This still sucks in cold air, and protects the filter from water damage and from getting knocked off. I also bought a slightly smaller fitler (a K&N Re0930 filter for $45) Also, I switched back to the 3 in dia hose rather than the 2.5 w/ the addaptor.
 
1 - 3 of 3 Posts
Top