Mazda MX-6 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
I just replaced my drivers side driveaxle on my 89 mx6 manual trans. I took it out for a drive the the drive axle popped out of the trans, I pushed it back in and drove a bit and it popped out again.
Is anyone familiar with this problem. I think it might have something to do with the retaining clip.
Any thoughts would be greatly appreciated.
 

·
Registered
Joined
·
24 Posts
Discussion Starter · #3 ·
I took the driveaxle back out today and checked the clip, it was there.
I guess I just didn't push it in hard enough. I messed around with it a bit today a pushed on it as hard as I could. It still doesn't feel like it's in their very securely. I test drove it though and so far so good. I'll guess I'll just have to wait and see.

Thanks for the response.
 
1 - 3 of 3 Posts
Top