Mazda MX-6 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
360 Posts
Discussion Starter #1
Hello all

I need some help/advice again. I am trying to install a new speedo and tacho and the old gauge cluster is too hard to access. I am trying to figure out which wire from the ECU is the speedo/tacho so I can take the signals from there. Does anyone know anything about this?

Thanx
 

·
Registered
Joined
·
711 Posts
Don't know about the tach wiring, but my speedometer is cable driven. No wiring for the speedometer. Why would you replace the speedo? Do you have a digital dash?
 

·
Registered
Joined
·
360 Posts
Discussion Starter #3
I am not replacing it. I bought an Apexi Rev/Speed performance meter. I just wanna know my stock performance before proceeding with any mods.
 
1 - 3 of 3 Posts
Top