Mazda MX-6 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
405 Posts
Discussion Starter · #1 ·
i went and got new endlinks, but when i went to put them on the spacer was rusted to the bolt. how did you guys get them apart? i have tried everything short of cutting it off. any idea's...
 

·
Registered
Joined
·
411 Posts
Cut it off...

The new links should have come with bolts, shafts, bushings and washers and nuts. You don't need your old ones anymore.

Cut it off...
 

·
Registered
Joined
·
1,426 Posts
Yeah for some wierd reason the on the left side of my car the front and back were rusted so I had to cut them with a hacksaw, while on the right side they came apart easily.

Cut them off.
 

·
Registered
Joined
·
405 Posts
Discussion Starter · #4 ·
cool, i dont know about the hacksaw though...i will use a high speed grinder. and $3.99 for new ones? for that i may replace every year. that spacer was a poor design, should have been made of aluminum so this wouldnt happen. a little late for them to care now..
 
1 - 4 of 4 Posts
Top