Mazda MX-6 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
428 Posts
Discussion Starter #1
I have a question on the installation of the mount next to the timing belt. Do i just jack the motor up a little to take the loading and remove and install the new. What about rotaion, will the motor fall back or forward a little?
 

·
Registered
Joined
·
711 Posts
The motor shouldn't roll. Be sure to put a block of wood between the jack and the oilpan.
 

·
Registered
Joined
·
68 Posts
mounts

Just got done puting new mounts on my mx-6. For the mount you are talking about. jack it up on the lip of the oilpan, with a cylinder jack. the other three mounts will hold it from moving around. hope this helps you out.
 
1 - 4 of 4 Posts
Top