Mazda MX-6 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter · #1 ·
hey everyone,

I am going to be getting an exhaust system soon for my mx-6 V6. I was wondering what the optimal piping diameter would be for a cat-back exhaust. I am planning on keeping n/a and spraying a little 35 shot of the good stuff maybe once every 4-5 days. I am planning no radical modifications to the engine like porting, new pistons etc, Im probobly going to just stay with intake, exhaust, Milder Cams and maybe a pulley along with the occasional spray at the track. I am very new to the KL motor and Im not sure whether I should look for a 2.25'' mandrel bent cat-back or a 2.5" crush bent etc. for my needs.

What size piping do you guys normally use for your 6's cat-back?

Thank you for your time
 

·
Registered
Joined
·
1,974 Posts
Vtecthis said:
hey everyone,

I am going to be getting an exhaust system soon for my mx-6 V6. I was wondering what the optimal piping diameter would be for a cat-back exhaust. I am planning on keeping n/a and spraying a little 35 shot of the good stuff maybe once every 4-5 days. I am planning no radical modifications to the engine like porting, new pistons etc, Im probobly going to just stay with intake, exhaust, Milder Cams and maybe a pulley along with the occasional spray at the track. I am very new to the KL motor and Im not sure whether I should look for a 2.25'' mandrel bent cat-back or a 2.5" crush bent etc. for my needs.

What size piping do you guys normally use for your 6's cat-back?

Thank you for your time
I'm running 2.5, but I don't know if that's the standard. Works well for me, but I do have a ZE
 
1 - 2 of 2 Posts
Top