Mazda MX-6 Forum banner

1 - 9 of 9 Posts

·
Premium Member
Joined
·
5,011 Posts
Discussion Starter · #1 ·
i need to tap my f2 pan for an oil drain, but i already have one that's tapped for the fe3. anyone know if they swap?
 

·
Registered
Joined
·
1,633 Posts
almost everything from the F2/F2T goes right onto the FE. With the exception of the head and intake. Im still planning on coming up at the end of this month, want to go to a batchlor party downtown Denver?
 

·
Registered
Joined
·
3,379 Posts
even the oil cooler fits, but it sits very close to the intermediate shaft mount and makes it a bitch to install it.
 

·
Premium Member
Joined
·
5,011 Posts
Discussion Starter · #6 ·
almost everything from the F2/F2T goes right onto the FE. With the exception of the head and intake. Im still planning on coming up at the end of this month, want to go to a batchlor party downtown Denver?
bachelor party? i dont care who's it is, count me in :p
 

·
Premium Member
Joined
·
5,011 Posts
Discussion Starter · #9 ·
well im guessing that evo626 had a kia pan, looked like it was setup for rwd.........the stiffener's did not line up, so i had to tap my f2 pan :shrug: oh well
 
1 - 9 of 9 Posts
Top