Mazda MX-6 Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
134 Posts
hey.. here is what my original plan consisted of:
3 leds
3 resistors
parellel wiring to the factory illumintion things on the back of the gauge cluster
and mounting in front where those 3 screw holes are..

make sure u get evenly diffused, bright blue LEDs
 

· Registered
Joined
·
134 Posts
buy em online i guess? look for LEDs and then compare the brightness (mcds) around 600+ mcd is bright so thatll be good for you.. for gauge cluster u just send the wire thru those screw holes nad hook it up in the back
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top