Mazda MX-6 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
96 Posts
Discussion Starter · #1 ·
you mentioned in another thread that you had coil overs...my friend told me they allow you to lower your car and raise without a lot of difficulty right? anyway, how much did they cost ya? thanks
oh and are you the one with the yellow mx? how did ya get the vinyl over the tail lights without wrinkling? did you do it in strips? or one piece? thanks man!
 

·
Registered
Joined
·
158 Posts
I have coilovers in my car too. I got them for $400 for all 4 corners. I believe some people have got them for as low as $340. They are very easy to raise and lower. All you need is a jack and they provide you with an allen wrench to loosen them. Check out JP's page at ...
http://www.geocities.com/jpmx6gt/
 

·
Registered
Joined
·
1,306 Posts
Thanks bigjeff.

mx6 LS , Th einstall is very simple, just time consuming. Just go to my page and click on the install link for it, that should get you going. On that page, click on the NEXT button to go to the next install page. For some reason people fail to see that button and think there's only one page. As far as raising and lowering it, it's very VERY simple, you don't even need to take the wheels off. Just jack the car up and loosen the collar with the allen key they provide and then twist it up and down. very simple.

I got mine for $340 shipped. Go here for details http://www.geocities.com/MotorCity/Shop/5212/gc.html

let me know if this helps or if yuo have any other questions.
 

·
Registered
Joined
·
96 Posts
Discussion Starter · #4 ·
hey, thanks for the info guys....but what about the tail lights? how did you apply the black vinyl and how'd ya do the cut outs?
 
1 - 5 of 5 Posts
Top