Mazda MX-6 Forum banner
1 - 1 of 1 Posts

· Registered
3,105 Posts
JDean55 said:
On the MX-6, you can adjust the hight of the hood by moving these 2 rubber things under the hood. I was just wondering what they should be proporly set at?? I looked at them and they were all the way down which means the hood closed totally, however, if I want to get air into the intake shouldn't I raise them alittle???

Those bumpers are there mainly for trimming the hood-closed height so the panel is flush with the fenders when closed. They also act as a cushion when closing the hood and to help to keep it from fluttering at high speed.

Your intake is getting air from a passage that runs in front of the A/C condensor, not from the gap where the hood closes. I'd leave them where they are if the panel-fit is right.

[Edited by Mike 94PGT on 03-01-2001 at 05:14 PM]
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.