Mazda MX-6 Forum banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 · (Edited)
Hey guys, ive read this board before and am just now getting serious about doing some mods to my car. i am in the middle of the tranny swap right now. I have a friend who ran a 14.9 in his 97 mustang gt and he keeps talkin smack.I want to shut him up. He's tryin to say that my 4 cylinder doesnt have anything for his V8. I am bone stock right now. What is it gonna take for me to beat this guy. Some one told me

1- Intake
2- Chip
3- boost gauge and controller (turned to 14psi)
4- exhaust
5- upper intercooler pipe
 

·
Registered
Joined
·
737 Posts
1- Intake
2- Chip
3- boost gauge and controller (turned to 14psi)
4- exhaust
5- upper intercooler pipe

If you do these things, you should'nt have a problem beating him. Make sure you have the proper gauges to monitor your boost/fuel before you turn it up. They are very important. Good luck.
 

·
Registered
Joined
·
3,655 Posts
if u wanna get exhasut, make sure its at least 2.5-3" manderal bending, and if u can put the exhasut straight out, it would be even better, but tis up to u if u wanna run a cat or not.
 
1 - 3 of 3 Posts
Top