[Rogue6]

I am getting ready to install my ZE into my 1993 mx-6ls 5speed and need to find out what intake (if any) will fit on the throttle body that faces the front of the car. I don't think the stock intake will work and who want's stock anyhow. I have searched but didn't find any answers. I don't really want the HKS... I was hoping to find a CIA. Thanks for your help

 

[JPMX6GT]

many people that have done the swap were still able to use cai's like Hotshot's or PRM's. It just takes a little bit of adjustment as far as the angle that it sits on. You might also have to leave the CAI's piping rubbing against another part of the car. Just make sure that no moving parts will be affected and you shuld be ok.

 

[Rogue6]

I read the "Super Probe" page (our bible) and remember saying that the only thing he couldn't use was the hotshot intake. I can't remember where but I think I recall reading somewhere that the PRm could be adjusted to fit... just looking for confirmation.

 

[MX-6 BOY jr]

it will fit, its just a bit on the tight side. Try my link at the bottom of the page on how I did mine.