Mazda MX-6 Forum banner
1 - 3 of 3 Posts

· Registered
134 Posts
Discussion Starter · #1 ·
Ok, first of all my NE1 sensor went out last week and I've been working so much that I haven't had a chance to fix it. I have a KLZE that I haven't put in so I thought I might be able to use the one out of the KLZE in the KL03. Nope... They're different. Is this going to be a problem when I go to install the new engine? The reason I ask is because there are two connectors on my disty now and the one on the KLZE only has 1 connector. If anyone knows anything about this I would appreciate it. Thanks...
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.