Mazda MX-6 Forum banner

1 - 3 of 3 Posts

·
Smot-Poker
Joined
·
1,499 Posts
Discussion Starter #1
So my idle had seemed to float at around 1500rpm when coming to a stop. then I would blip the throttle gently while in neutral and it would fall back to 750rpm(where its supposed to be at)
I noticed the tps kinda "sticks" at a spot just before it falls to an idle position. Can I just squirt it with some oil? or what?
if so, what kind should I use? how else (if any) could I go about fixing that?

Lates...:)
 

·
Registered
Joined
·
108 Posts
not recommended... i messed up my TPS by merely cleaning out my throttle body. you need to be careful around sensors. recommend replacing it. buy the part and install it yourself. to (calibrate?) adjust it properly you'll need a voltmeter, and I can post the procedure here if you are interested.

best of luck,
 
D

·
Guest
Joined
·
0 Posts
yes can you please post the procedure - such as what wire at the ecu is the signal from the tps and what it should be at wot and closed
 
1 - 3 of 3 Posts
Top