Mazda MX-6 Forum banner
1 - 4 of 4 Posts
G

·
Discussion Starter · #1 ·
Help I need help on a problem with my Mx-6 I replaced the fule pump and I replaced the ignition module and coil but it's not gitting fire to the engine and i think it's the computer but im not shure if anyone can help i would apperciate it
 

· Registered
Joined
·
1,752 Posts
Did you put the fuel relay back in?
Is the PCM working properly?
Have you made sure the timing is set at Top Dead Center?
Have you checked the Crank Position Sensor?
Is it getting fuel?
Is it throwing a code?

Just some starters

-Andrew
 

· Registered
Joined
·
1,282 Posts
Why would you replace your fuel pump if your not getting "fire", tipicaly when someone say they're engine isn't getting firem, it means that the spark plugs arn't sparking, so how would a fuel pump get your spark plugs to fire....I would look into things like the distrubitor cap and rotor, ignition coil (I think you said you did that), plug wires and plugs. Then an ignitor switch ect, basicaly Anything that has to do with providing spark to the plugs, a new fuel pump will not effect spark in any way...unless you just replaced it because it needed to be anyway.

Methman
 
G

·
Discussion Starter · #4 ·
I replaced the fule pump because the last one quit working
Meth man


xxtavixx thanks for the tip you been a great help I the whole thing was caused by the air bag sensor shutting the computer down and was not letting the gas get to the engine to ignite
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top