Mazda MX-6 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
321 Posts
Discussion Starter · #1 ·
I have a question. I have a 95 V6 LS with a weapon r intake custom 2 1/2" catback dualed out exhaust and 50shot nitrous.
I dont drag the car so I am thinking of removing the nitrous. because I was told it is real hard on your engine. What mods could I add to replace the nitrous. I drive my car everyday so I don't want to blow my engine.
 

·
Registered
Joined
·
283 Posts
well you can do headers from hot shot or pacesetter also you can get a new throttle body.
 

·
Registered
Joined
·
321 Posts
Discussion Starter · #3 ·
cool thanks for the insight. how good is the pacesetter stuff I have never heard of them. And what websites sell hotshot do you know. I hope it is not as costly as the borla headers those jokers are about $650
 

·
Registered
Joined
·
48 Posts
????Pacesetters

I have heard some good and bad comments regarding the pacesetters. The good: They are cheap ~$120 for the basic setup (painted black) more for the ceramic coated headers, not sure about the price, probably about $300-$350. The pacesetters, when working properly, give the best performance and sound of any header made for the car. The bad: The basic headers (painted black) seal poorly and have weak welds, they rust after the paint burns off, and the quality is generally poor. The ceramics won't rust, look better, and probably last longer, but they are double the price. Look at http://www.ptuning.com and http://www.jcwhitney.com I am pretty sure at least one of these sites has them. Hope this helps... :)
 

·
Registered
Joined
·
321 Posts
Discussion Starter · #5 ·
hey thanks this is real helpful. anything to keep from paying $650. I will look into the ceramic coated ones. Do you know much about a bored throttle body?
 
1 - 5 of 5 Posts
Top