Mazda MX-6 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1
i need to get rid of my 18'rimz
aus$1,500 w/out rubber....sorry none neg

if i get any replies here i'll be at the campbelltown pickup point on Sunday 6th May so if u want them bring the DOUGH$$$ and it'll be yours

her is the pickz if u wanna see them now

 

·
Registered
Joined
·
233 Posts
Sorry I,m not a buyer, I think the 18" are a bit much for my daily driver.
Good luck selling em. what are you putting on?

A question - Duuh. Whats the advantage of going lower at the back?

I've gone 26mm alround but wanted a bit more.

Perhaps I should just do the rears?

tia

4wsb
 

·
Registered
Joined
·
61 Posts
Discussion Starter #3
im not actually putting anything eles on.... im actually gonna sell the car in a few weeks and i just wanted to sell the wheels seperate, thats all.....as for the new car....

well im pickin up a nissan r33 skyline in abut a week or so....

about the lowering job.. i was advised that the lowest possible on the stock shock was 1'/front 1.5/rear...i actually wanted to get a 2' drop all around, but.....the stockies would'nt b able 2 handle it, so this was the best option...
 

·
Registered
Joined
·
672 Posts
What sort of 18" rims are they??

They dont look too bad!!!
 

·
Registered
Joined
·
61 Posts
Discussion Starter #5
the rims will fit the 2nd gen MX6 without and probz
they are called "Super Stars"
 
1 - 5 of 5 Posts
Top