Mazda MX-6 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
Hey guys, I'm re-installing my 6 disk changer (factory) into my MX-6 LS and I ran into a problem... Probably very simple, dont smack me!
There are three primary wires to get the juice flow'n to the changer. Black (I think its the Ground), Red (+) and Yellow (?). How the hell do I rewire this car? All I need to do is know how to re-run the black, red and yellow wires to the disk player, all other wires are already hooked up to the front disk player. Any help would be appreciated, thanks!
 

·
Registered
Joined
·
148 Posts
Black-- Ground
Red-- +12v ignition switch
Yellow-- +12v Constant supply


Just tap into the harness behind the head unit and run the wires (red and yellow) where ever you'll be putting the cd changer. Or if you can find a constant 12v supply closer use it, but the red will have to be connected to the 12v power source that is connected to the ignition switch (12v supply when the key is in acc position and running position, off when the key is taken out.
 
1 - 2 of 2 Posts
Top