Mazda MX-6 Forum banner
1 - 20 of 28 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
For shipping and location purposes, this car is located in southeastern massachusetts.


1994 mazda mx6 ls v6 black exterior and tan leather interior. I have almost all parts for 1994 mx6, some in excellent condition, others may need a few repairs. The engine is from a 1996 (2.5l v6) mazda 626, I tried to do an engine swap but electronics werent compatible and it has been sitting in my driveway so I have decided to part it out. here is a small price list for most parts... (these prices are excluding shipping).. and are negotiable depending on the condition of the part. I, However, am a student and will not have time to take the car apart to get you your part until around may of 2005.

Windshield 115$

Window motors 50$

Winshield wiper motor 50$

Wiper fuild reservoir 25$

Water pump 45$

Sun roof 190$, sun roof motor 190$ or complete for 230$

Trunk w/ spoiler (including brake light) 400$

Torque converter 70$

Automatic Transmission 800$

Throttle valve 250$

Steering wheel 40$

Steering column and electronics 190$

Starter 100$

Front left and Right Seats 250$each

Rear seat with folddown 125$

Seat belt 45$

Trailing arm 50$each (or all four for 190$)

Rear bumper (w/ primer) 300$

Radiator 200$

Power steering pump 125$

Instrument cluster 60$

Ignition switch 90$

Hood 200$

Hood hinge 20$each

Heater/ac control 140$

Fuel tank 250$

Fuel pump and assembly 145$

Front doors (complete) 400$ each

Frame- ?????????

Front fenders 100$ each

Dash wiring harness 125$

Engine wiring harness 90$

Distributor for 94 v6 ls mazda mx6 270$

Distributor for 96 v6 mazda 626 400$

Dash 400$

Control arm lower front 100$each

Control arm upper fron 100$each

ECU 300$

Rear glass 190$

Alternator 100$

1996-626 (2.5l v6) engine- 600$






OR the total car for 2800$


picture can be taken and sent of various parts depending on availability of time. All prices are United States Dollar. Thank you for taking your time to read this thread.
 

·
Registered
Joined
·
2,608 Posts
WOW ... Uhh ... Thats some REALLY HIGH prices on those parts there ...

Also .. If you cant provide the parts until May why even make this thread now ? Id just put the car up for sale if you dont have the time to pull the parts ... But, youll never get $2800 for a non-running ATX with tan leather ...

Just my $.02 ... Though ...
 

·
Registered
Joined
·
79 Posts
Sorry, I don't want to offend anyone. When I read this a huge red flag went up. In the past, I've found (with Ebay especially) that when U.S. addresses list prices with the dollar sign after the price, they are usually NOT legitimate.

I have no idea if this is legitimate or not, but in light of the recent website problems, I felt compelled to post. I hope I'm wrong.

TC
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #4 ·
in reply to thefallenangel1 and track6

to thefallenangel1- im sorry that the prices appear high, thats why i said negotiable, i am unfamiliar with prices of used parts, I got those numbers by calling junkyards and searching online for all used parts then i knocked 20% off those prices because most of the parts are new but have been sitting for a while. Dont be alarmed by prices, if you are interested in a part make an offer i just put those prices up because i thought they were low. I know the 2800$ sounds ridiculous but if i dont want to just dump it thats why im gonna part it out and i posted it now because there may be someone planing on buying a project car and wont need it right away.

to track6, i put up the USD next to the prices because I travel back and forth to canada to go snowmobiling on the weekends, and on everything i put down USD because of habit. Besides on other forums i have looked to buy stuff and it ended up being in pounds and was much more than what i thought i was paying. Sorry about the confusion.





Prices are negotiable, you make an offer or request and I will see what I can do

-J
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #6 ·
1500$ excluding shipping (i dont have a location for you and what method you would prefer), the car would still need a little work, the rear bumper is primed and would need to be painted, and the front bumper would either need some fiberglass or be replaced. It may also need some cleaning (which if i am given enough time should be able to do effectively)..
 

·
Banned
Joined
·
1,048 Posts
read the thread carefully, this guy isnt a bad guy but his prices are WAY too high..... down below are the prices that I as a member of mx6.com and as a person who has parted out a few mx6's, have hooked him up with prices of what the items go for...

he didnt put the prices in green, i did, so if he refuses the green price then that is his choice, i just wanted to help!!
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #8 ·
what the heck are you talking about

why do you keep saying that im a scam....

Im sorry that i dont know much about cars, to get prices i went online and called local junkyards to get prices.....


if you dont believe me... look at my posts from months or even years ago about trying to find a solution to get my car started...

next time... do research before you say anything...


this is really obnoxious...


dont accuse me of anything, i have the right to report you all to the authorities for miss threading on my post. I have done nothing to deserve this.

if you dont want to buy any parts... maybe you could give me some advice as to what i can do to get it started..



its a 1994 mazda mx6 ls v6, my sister blew the engine a while ago, and i bought a 1996 mazda 626 engine to put in the car. After I spent a few months trying to do an engine swap i went to turn the key and cant get a spark. The engine tries to turn over but no spark occurs. I have tried distributors for a 1994 mx6 and for a 1996 626 and neither could get a spark. Im pretty sure all the grounds are connected, and all electronics are hooked up. I had to fiddle with the oxygen sensors to get the connectors to fit the new engine. I am at a loss for words, but please dont insult me like that its not fair, i just want to part the car because i dont want to start spending money on stuff like crank sensors or ecu's if i dont know what the problem is.
 

·
Registered
Joined
·
2,608 Posts
If I needed a part asap .. Whats the soonest I could get it from you ?
 

·
Registered
Joined
·
4,659 Posts
Mazdamaniac94- I think the best way to put it is that we buy from people on the site becouse we get good deals, so to pay for the junkyard price+shipping would be lossing money
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #11 ·
well im probably just gonna remove this thread... i cant even work on the car because its at my home in southeastern mass, right now im in school in up north New Hampshire and i wont be back home until after finals in mid may......... but since everyone has been so... well.... uncooperative....im just gonna sell it locally that way i dont have to worry about shipping... and maybe it will give me an opportunity to figure out what is wrong with it
 

·
Registered
Joined
·
4,659 Posts
mazdamaniac94 said:
well im probably just gonna remove this thread... i cant even work on the car because its at my home in southeastern mass, right now im in school in up north New Hampshire and i wont be back home until after finals in mid may......... but since everyone has been so... well.... uncooperative....im just gonna sell it locally that way i dont have to worry about shipping... and maybe it will give me an opportunity to figure out what is wrong with it
I wasn't trying to be rude, just tryed to exsplain
 

·
Banned
Joined
·
1,048 Posts
Mazdamaniac - im sorry that i kinda blew up at you, but seriously man the prices that you have given us are SERIOUSLY blown up.... like you have some things on there that you want like 400 dollars for when they are only worth like 50...... that to me is a complete scam...

and yes you can report to anyone you want, but there is nobody that can do anything about a member trying to look into if someone is trying to scam people on this site....

and i actually did look you up and you have a total of 6 posts EVER!!!! so how does that qualify you to come on here and mark up prices like 400%

since i dont believe i am an unfair person and or a mean one, and since i have parted out like 5 cas on this site in the past then i will help you out and let you know exactly what the stuff that you have is worth on here...

if you follow what i tell you i am sure that most of your stuff will sell...

here ya go.....

 

·
Banned
Joined
·
1,048 Posts
Windshield 115$ - $65 (local pick up only, no one ships glass)

Window motors 50$ - $25

Winshield wiper motor 50$ - $25


Wiper fuild reservoir 25$ - $17

Water pump 45$ - no one buys a used water pump, but if its new then this price is ok

Sun roof 190$ - $100

sun roof motor 190$ or complete for 230$ - $25

Trunk w/ spoiler (including brake light) 400$ - $120

Torque converter 70$ - $35

Automatic Transmission 800$ - not many buy used trannys, but if they did $300

Throttle valve 250$ - $20

Steering wheel 40$ - $25

Steering column and electronics 190$ - $80

Starter 100$ - $40

Front left and Right Seats 250$each - $250 for both if they are black leather, if not 75 for both

Rear seat with folddown 125$ - if its TAN $30, if its black leather $75ish

Seat belt 45$ - $30

Trailing arm 50$each (or all four for 190$) - $50 for all


Rear bumper (w/ primer) 300$ - $100

Radiator 200$ - $50

Power steering pump 125$ - $35

Instrument cluster 60$ - $30

Ignition switch 90$ - $20

Hood 200$ - $100 + shipping

Hood hinge 20$each - $20 for all

Heater/ac control 140$ - $25

Fuel tank 250$ - $50

Fuel pump and assembly 145$ new ones are like $85

Front doors (complete) 400$ each - $175

Frame- ????????? - $200

Front fenders 100$ each - good

Dash wiring harness 125$ - $45

Engine wiring harness 90$ - $30

Distributor for 94 v6 ls mazda mx6 270$ - $60

Distributor for 96 v6 mazda 626 400$ - $85

Dash 400$ - $100 only if black

Control arm lower front 100$each - $20 each

Control arm upper fron 100$each - $20

ECU 300$ - $50

Rear glass 190$ - no one really buys glass and or ships it...

Alternator 100$ - $35

1996-626 (2.5l v6) engine- 600$ - $350ish

THESE ITEMS INCLUDE SHIPPING, OR MOST DO.... THIS IS ABOUT WHAT THEY SELL FOR ON HERE....
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #15 ·
thanks for the help, but im just gonna rip out the engine over the summer and try again, i dont know if the electronics will match up, but if they dont at least i will have a completely cleaned shell to sell. maybe this posting was a wake up call for me to get off my butt and try to redo it, its such a pain.. especially with little know how and even littler know-how with electronics. and by the way that distributor for a 96 626 was brand new, never used.. its actually worth more than 400... my wallet can tell you so. and how can those prices include shipping, cripes... you would lose money on the 25 dollar parts... why dont i just give it away????.......



back to the same of grind of school...only 6 more years... (im a sophomore now) planing on post undergrad schooling....
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #17 ·
im not parting it out anymore, after several comments from other members, i refuse to conduct business on here. Instead of being constructive there were just downright offensive. I know the prices may have seemed high, but like i said, im not just gonna give them away i do have college bills to pay. so sorry, im just gonna work on it over the summer now, im not longer parting it out.
 
1 - 20 of 28 Posts
Top