Mazda MX-6 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
371 Posts
Discussion Starter · #1 ·
i need a web address for a performance engine parts company. i went to the flatlanderracing site and it looks like i'm only able to get topline which i think are made for stock or a little above stock replacements. i want a light and very durable piston for extreme boost and 7500rpm(i am also gonna go full floating instead of pressed in wrist pins). i need h-beam or better rods (i'm thinking eagle rods) i don't need bearings i'm gonna use the toga bearing kit on flatlanderracing.com but i do need full valve train , high flow oil pump(preferably electric and mechanical replacement) and a copper head gasket... all help is great so plz type away

PEACE
richard
 

·
Registered
Joined
·
707 Posts
if you talk to the people at flatlander they will be able to make costum pistons or rods for you at a lower price than most other companies and help you better to answer questions on parts to upgrade thevalve train.

tom
 

·
Registered
Joined
·
103 Posts
In our Chevy V8 engines built by Pro Power(http://www.chriscarlsonracing.com/carlsonwebsite3703_014.htm
we use JE pistons. (http://www.jepistons.com/index.asp)
These motors put out over 820 naturally aspirated horse power from a 360 cubic inch small block. I know JE offers custom pistons, and I KNOW they last!
SPECS:
(360 cubic inch small block Chevrolet, Chevy bow tie block, crank specs:16lbs, gunbarrel drilled, knife edged, Honda rod journals, on-and-on. 18 degree heads, holly 750 carb, dry sump oiling system. Revs to 9000rpm all day. Revs to 10,00rpm once! Cost: $31,000)
Here's JE's custom order page:
http://www.jepistons.com/pdf/custompistons-orderform.pdf
Oh, just in case you are curious, here's where those engines live:
http://www.xtremedirtcars.com/
 

·
Registered
Joined
·
371 Posts
Discussion Starter · #4 ·
yeah i was thinkin je pistons, i've heard a lot of the honda guy's use them and aparently there a good combo with eagle rods. i don't know about flat lander if they can get me je's and eagle rods i think will go with them. i not to sure what to do with the valve train though i want as much flow as possible and i wana rev more that's why i wana go with full floating pistons(among other mods) i think i need to stiffen up the springs and keep them dual,it wouldbe good if i could get titanium retainers also!!!!. i would completly replace the valves cause i'm having them coated.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top