[ricdanger]

I've just ordered some rear sway bars for the '6. They're 22mm and have to be manufactured to order... - we don't get the ADDCO etc gear down-under.

Question is, they are designed for the Probe, so will they work/fit on the '6???

Anybody with 2cents welcome to reply.

 

[BOWDWN2MX6]

Yes. They will work for either car.

 

[superflymx6]

What or is there a difference in the thickness of the sway on the GT and the V6 mx6? i heard that the front mx6 one is smaller. is that right? what about the back one.

 

[ricdanger]

If we get no answer to this I'll get my mechanic guy to measure the bars when he installs the new bar and then check with my probe buddies.

 

[Greg S]

The rear bars are the same on both cars. The front on the MX-6 is slightly smaller than the one on the Probe. That is the only differences.

 

[BOWDWN2MX6]

The rear Addco was a 10 minute job. Half of that was fighting stubborn nuts with WD-40. BTW, remove the nut on the endlink with a 4mm allen wrench (in the end of the bolt) and a box-end wrench. I have seen SOOO many posts where people haven't figured this out and CUT the endlink.