Mazda MX-6 Forum banner

Remove sunvisor without damaging cover?

1084 Views 1 Reply 2 Participants Last post by  bmxfuel007
I am trying to pry off the blanking cap or clip cover on a
sunvisor with a small flathead screwdriver, but am afraid
of damaging the cover or tearing the cloth next to it.
Any tricks!!!
1 - 2 of 2 Posts
do it very carefully :p i suggest doing the center section first, then the sides. use two small screwdrivers, one stuck in the middle, then put one in the side and at the same time twist a little on both screwdrivers and they should just pop off. Yes, i've broken these before. each one has 3 little clips, middle, one on each side
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top