Mazda MX-6 Forum banner

1 - 5 of 5 Posts

·
Smot-Poker
Joined
·
1,499 Posts
Discussion Starter · #1 ·
And wow!.. Im pretty confident that it made a considerable increase in performance...

T'was a messy job but its done...

It is definantly louder then before..

I figured that since im gonna need a new one soon anyway.. im just gonna run it like this till the emmisions papers come my way... then Im gonna buy a high flow cat...

any questions let me know...

cheers
 

·
Registered
Joined
·
283 Posts
how did u do it man i have a 93 mx6 v6 auto
 

·
Smot-Poker
Joined
·
1,499 Posts
Discussion Starter · #3 ·
Sorry

I didnt actually do it myself... but I watched my mech guy do it... He just pulled it out by melting the nuts that were stuck with a blow torch... then he took a hammer and a long screw driver and just bashed the shit out of the insides until it all came out.. then he put it back on with new gaskets and bolts... viola! hollowed Catco :)

Cheers
 

·
Registered
Joined
·
3,092 Posts
a hammer and screwdriver?!?!?!?! WTF?!?!?!

use a pole a lil smaller than the inlet/outlet diameter.
stand the pole on end, and slam the cat over the pipe until all the goodies come out... it only took me a half an hour or so...
 

·
Smot-Poker
Joined
·
1,499 Posts
Discussion Starter · #5 ·
yup

he did that too... it took him longer to get it off then it did to actually hollow it out :)
pretty intresting sight if you ask me..

cheers
 
1 - 5 of 5 Posts
Top