Mazda MX-6 Forum banner

1 - 17 of 17 Posts

·
Registered
Joined
·
2,879 Posts
Discussion Starter · #1 ·
So I was getting some of these made for myself and thought, Hey there are probably lots of other guys that could use this So here they are guys let me know if your interested these are all made out of mild steel.



They are made so you have enough room to weld on them.
 

·
Registered
Joined
·
3,379 Posts
how did you cut those? i might have you make me a block off plate for my dizzy hole and a bracket for the coilpacks :D
 

·
Registered
Joined
·
2,879 Posts
Discussion Starter · #4 ·
I had them made, If you guys can draw really good and take good measurements I can get just about anything made. There is a guy that I know that does a lot of machining.

i could probably pretty easily get a block off plate for the disty, I'll just send him an old dissty that he can take the measurements off of.
 

·
Registered
Joined
·
2,684 Posts
i could actually use one for the t bird intake side. I havent asked any shops around here because im busy and thats the only thing holding me back from installing it.
 

·
Registered
Joined
·
3,379 Posts
i could probably pretty easily get a block off plate for the disty, I'll just send him an old dissty that he can take the measurements off of.
well its for the fe3, so ill have to draw you up something. ill get at that later today hopefully.
 

·
Banned
Joined
·
2,630 Posts
how much shipped to 90017? for the compressor side flanged
 

·
Registered
Joined
·
3,379 Posts
unless your doing a bulk buy, you dont need mod approval. just make a for sale thread in the for sale section and sell from there.
 

·
Registered
Joined
·
2,879 Posts
Discussion Starter · #13 ·
Yes but I need the exact drawing with exact dimensions.
If someone could send me a fe3 dissty I can get it made.
I can make plates for a f2 dissty because I have one.
 

·
Registered
Joined
·
2,879 Posts
Discussion Starter · #14 ·
Seeing that a good amount of people are interested FE3 disty block off plates If someone wants to send me their busted disty I can get some made and for the person that sends me the disty I can give them a discount
 

·
Registered
Joined
·
3,379 Posts
ill double check but i think the f2t dizzy is a direct fit. (other than its too short/long for the cam)


also where do you buy sheet aluminum to cut up like that? im gonna have to get some sooner or later to make other mountings plates/brackets.
 

·
Premium Member
Joined
·
18,203 Posts
Dark, let me get back to you about this...
 
1 - 17 of 17 Posts
Top