Mazda MX-6 Forum banner

What do you recon?

  • To get....

    Votes: 3 60.0%
  • Or not to get....

    Votes: 1 20.0%
  • Dunno....

    Votes: 0 0.0%
  • Don't care....

    Votes: 1 20.0%
1 - 3 of 3 Posts

·
Registered
Joined
·
5,550 Posts
Discussion Starter · #1 ·
Actually... I was just thinking, now that all the cards are on the table about these wheels, what about a " Poll"
If you where in my situation ...
Free 18ns {or very close to it}
2ws{so they should fit}
Wrong size tyres {for speedo and perhaps acceleration}
OK design {a bit European for a Jap car}
And I only have the factory rims at the moment...
Would you get them???
P.K.:)
 

·
Registered
Joined
·
55 Posts
yes a definate GET.

Even paying for new tyres, it will still work out cheap.

Not sure if a 225x35 (the size you need) will stretch over a 18x9" rim though.. actually VERY much doubt it.

Perhaps a few phone calls to some reputable tyre retailers may help you out.

As pointed out above, if its a no-go, you can sell them later. The stud pattern is the same as the 200SX, Skyline and Supra.. so you should have no probs finding a buyer.
 
1 - 3 of 3 Posts
Top