Mazda MX-6 Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
269 Posts
Discussion Starter · #1 ·
I had to replace my valve cover gasket so I painted the valve cover at the same time. Before viewing the crappy pictures, the cover is painted in flat black engine paint, and we polished the Mazda emblem that screws onto the top of the cover.




Ryan
 

· Registered
Joined
·
269 Posts
Discussion Starter · #5 ·
Good question. From what I saw it doesn't look removable...just a smooth surface that was painted. But I could be wrong.
 

· Registered
Joined
·
269 Posts
Discussion Starter · #7 ·
Only reason I'm choosing not to do my intake manifold...it took me about 20 minutes to get that large pipe off the throttle body and back on. It just doesnt move well as it looks it would.

[Edited by rmtaylor on 02-13-2001 at 11:26 AM]
 

· Registered
Joined
·
269 Posts
Discussion Starter · #10 ·
"ALL YOUR BASE ARE BELONG TO US"

Oh let me put the right valve cover on then...ass.

[Edited by rmtaylor on 03-06-2001 at 12:32 AM]
 

· Registered
Joined
·
269 Posts
Discussion Starter · #13 ·
Yeah it is tough to keep clean. I keep getting water spots on it everytime it rains.
 

· Registered
Joined
·
269 Posts
Discussion Starter · #18 ·
It only came to my attention about a month ago. It was over in about a week : )
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top