Mazda MX-6 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
76 Posts
first of all, you have to figure out the setup you will be running. 1/4 mile times cannot be estimated by"how fast will i go at 9 psi"
because 9 psi on different size turbos will result in different hrsepower/lag/powerband etc. And still even that will not be enough. Will you be upgrading injectors, fuel pump, exhaust piping and downpipe size, full standalone etc. all of these things contribute to your times as well. Intercooler? How big?, how small? Intake piping diameter? All of this must be planned out before you begin to start guesstimating.
 

·
Registered
Joined
·
76 Posts
nice.......what mods would i need to run higher boost...say for exaple 12-15psi?
1. A good fuel system
2. Hour after hour of tuning
3. Lots and lots of cash
4. Internal work Possibly(not sure what stock internals on K series motors can handle, but i do know that with enough fuel and a timing retard you may be able to go farther on stock internals than most would think)

Good luck to you, i reccommend spending the next few months researching before you go and start buying things.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top